EnGenius ENSTATION2 Spécifications télécharger pdf (Page 19)

2-2

NSTALLATION

NSTALLING

THE

EVICE

2.2 Installing the Device

Installing the EnStation2 on a pole or wall optimizes the wire-

less access range.

Note:

Only experienced installation professionals who are

familiar with local building and safety codes and, wherever

applicable, are licensed by the appropriate government

regulatory authorities should install the EnStation2.

Pre-Installation Guidelines

Select the optimal location for the equipment using the following

guidelines:



The EnStation2 should be mounted on a 1"-4" pole. Its

location should enable easy access to the unit and its

connectors for installation and testing.



The higher the placement of the antenna, the better the

achievable link quality.



The antenna should be installed to provide a direct, or

near line of sight with the Base Station antenna. The

antenna should be aligned to face the general direction of

the Base Station.

Installing the Device

To install the EnStation2, use the following procedure to mount

the device on a pole and refer to the figure below:

Remove the bottom cover protecting the RJ-45

connectors.

Insert an Ethernet cable into the RJ-45 port labeled LAN.

Install the bottom cover to protect the RJ-45 connectors.

Remove the power cord and PoE injector from the box

and plug the power cord into the DC port of the PoE

injector.

CAUTION!

ONLY USE THE POWER ADAPTER SUPPLIED WITH THE

TATION

USING A DIFFERENT POWER ADAPTER MIGHT

DAMAGE THE

TATION

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 97 98

Commentaires sur ces manuels

Pas de commentaire

EnGenius ENSTATION2 Spécifications Page 19

Commentaires sur ces manuels

Produits connexes et manuels pour Points d'accès WLAN EnGenius ENSTATION2