EnGenius ECB-3220 Wireless Indoor Access Point Manuel d'utilisateur télécharger pdf (Page 10)

11b/g Wireless Client Bridge/AP Version 2.1

2 Understanding the Hardware

2.1 Hardware Installation

1 Place the unit in an appropriate place after conducting a site survey.

2 Plug one end of the Ethernet cable into the RJ-45 port of the device and another

end into your PC/Notebook.

3 Insert the DC-inlet of the power adapter into the port labeled “DC-IN” and the

other end into the power socket on the wall.

This diagram depicts the hardware configuration

2.2 IP Address Configuration

This device can be configured as a Bridge or Access Point. The default IP address

of the device is 192.168.1.1. In order to log into this device, you must first configure

the TCP/IP settings of your PC/Notebook.

1. In the control panel, double click Network Connections and then double click on

the connection of your Network Interface Card (NIC). You will then see the

following screen.

Brid

e/APPC

Power Outlet

Ethernet

AC/DC cable

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 53 54

Pas de commentaire

EnGenius ECB-3220 Wireless Indoor Access Point Manuel d'utilisateur Page 10