EnGenius ENH200EXT Manuel d'utilisateur télécharger pdf (Page 27)

5 System

5.1 Switching the Operation Mode

The ENH200EXT supports 4 modes: Access Point, Client Bridge, WDS Bridge, and Client Router.

In order to switch between the operating modes, please go to System -> Operation mode.

To begin, click System Properties under System Section.

• Device Name: Specify a name for the device. It is not the broadcast SSID; this will be

shown in SNMP management.

• Country/Region: Select a Country/Region to conform to local regulations.

• Operation Mode: Select an operation mode via a Radio Button.

Click Accept to confirm the changes.

Accept does not apply the changes, you must go to Status -> Save / Load to

apply the new settings. Please refer to Chapter 4.1 for more information.

If you would like to use Access Point with WDS Function mode, please select

Access Point Mode and then enable WDS function in the Wireless Network section.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 85 86

Pas de commentaire

EnGenius ENH200EXT Manuel d'utilisateur Page 27