EnGenius ENH710EXT Manuel d'utilisateur télécharger pdf (Page 28)

WDS Bridge Mode

In WDS Bridge Mode, the ENH710EXT can wirelessly connect different LANs by configuring the MAC address and

security settings of each ENH710EXT device. Use this mode when two wired LANs located a small distance apart want

to communicate with each other. The best solution is to use the ENH710EXT to wirelessly connect two wired LANs, as

shown in the following diagram.

WDS Bridge Mode can establish up to four WDS links, creating a star-like network.

Note:

WDS Bridge Mode does not act as an Access Point. Access Points linked by WDS are using the same frequency

channel. More Access Points connected together may lower throughput. This configuration can be susceptible to

generate endless network loops in your network, so it is recommended to enable the Spanning Tree function to

prevent this from happening.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 73 74

Pas de commentaire

EnGenius ENH710EXT Manuel d'utilisateur Page 28